Laney RB1 Benutzerhandbuch
Seite 10
10
9
8
7
6
5
4
3
2
1
Input socket for connection of bass guitars.The socket will accommodate High or Low output basses, either Active or Passive.
This control is used to set the level of gain present in the pre-amp. The higher the level of gain, the more the signal will clip
producing distortion. The Gain control should be used in conjunction with the Volume control to produce the desired signal
characteristics.
Engages and disengages the on-board compressor, this compresses the input-signal giving a punchier sound. In association with the
compressor are two LEDs, one indicating that the compressor is engaged and one indicating the compressor is active. The amount of
compression is controlled by the Gain control. The higher the setting the more compression. With most guitars compression will
begin at about 5-6 on the control. It is possible to have the compressor engaged but it only be active during certain periods of
playing - typically the most dynamic sections.
Controls the boost and cut of the low-frequency response of the pre-amplifier.
Controls the boost and cut of the mid-frequency response of the pre-amplifier.
Controls the boost and cut of the high-frequency response of the pre-amplifier.
Sets the overall listening level of the amplifier.
3.5mm stereo jack socket provided for connecting an external sound source such as; CD players, MP3 players, etc.
3.5mm stereo jack socket for connecting headphones and when connected, the internal loudspeaker is automatically switched off.
Indicates power is connected and the amp is switched on.
FRONT PANEL CONTROLS
10
9
8
6
7
4
5
3
2
1
10