Electrolux EWW 148540 W - Handbuch (Seite 11)

Soil Level Icon Type of fabric
Super Re-
fresh
1)
2) For refreshing a very
few items only
1) We recommend you to reduce the load sizes (see
Washing programmes table).
2) When you select this option the relevant icon appears
just for a while and then it disappears immediately.
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 8 (if you wish to change the Time Man-
ager option, you must cancel the running
programme and make your selection again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button 8 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 8 .
If the icon 2.8 disappears after some mi-
nutes, the door can be opened.
If the icon 2.8 does not go off, this means
that the machine is already heating or that
the water level is too high. Do not try to
force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
. After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!) .
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8 .
At the end of the programme
The machine stops automatically. Three
blinking zeros (
) appear on the dis-
play and the pilot light of button 8 goes off.
Some acoustic signals sound for a few mi-
nutes.
If a programme or an option that ends with
water left in the tub has been selected, the
icon 2.8 remains displayed to indicate that
the water must be emptied out before open-
ing the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, the icon 2.8
disappears and the door can be opened.
Turn the programme selector dial to
to
switch the machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleas-
ant smells.
Stand by : once the programme has finish-
ed after a few minutes the energy saving sys-
tem will be enabled. The brightness of the display is reduced. By pressing any button
the appliance will come out of the energy
saving status.
electrolux 11