Ultimate Speed Z31365 - Handbuch (Seite 5)

5 GB/IE
Tyre stand
Q
Intended use
The tyre stand is intended for the storage of wheel
rims with or without tyres. This product is not intend-
ed for commercial use.
Q
Description of Parts
1 Central linking piece
2 Screws
3 End rod section (with plug)
4 Down rod section (without plug)
5 Extension legs
6 Pin
7 Storage container (2 parts)
8 Plate
9 Screws
10 Tread depth gauge
11 Air pressure gauge
12 Tyre protection cover
13 Tyre chips, 4 different colours
14 Hexagon wrench
Q
Technical data
Suitable for all currently available car rims up to
18 inches (approx. 46 cm).
Suitable for all common car wheel rims with tyre
widths up to 225 mm.
Material: steel, aluminium,
PP (polypropylene)
Total height
(without container): ~1.13 m
Weight (without
accessories):
~1.9 kg
Max. load capacity: 100kg
Q
Accessories
Tyre protection cover 12
With Velcro fastening
Tyre chips 13
In 4 different colours. Labelling: front left, right
front, left rear, right rear
Air pressure gauge 11
For easy measurement of air pressure. Measure-
ment range: 0.7 – 3.5 bar / 10 – 50 psi
Tread depth gauge 10
Measurement range: 0 – 20 mm; shows statutory
minimum tread depth (1.6 mm) and recommended
tread depth for winter tyres (4 mm).
Storage container 7
For practical storage of assembly equipment.
Safety information
Do not tilt the tyre stand!
WArnIng! rISk of Injury To
PerSonS! DAnger of TIPPIng!
J Place the tyre stand only on a level, flat and
solid surface. The base must not slope, as the
stability of the rack cannot then be guaran-
teed. (Use spirit level to check.)
J The tyre stand may not be used for any other
purpose since this could cause injury.
J The tyre stand may not be moved when sup-
porting a load (rims + tyres) since there is a
danger that it could tip over.
J The tyre stand may not be tipped since this
could cause injury.
J The tyre stand may not be used if damaged
since this could cause injury.
J Always operate the tyre stand using two
hands.
J Due to danger of tipping,
load tyre stand ONLY from
above, in order to avoid
injury.
Q
Assembly
Decide on the final location for your rim tree before
putting the wheels on to it.
1) First of all fit the central linking piece 1
and the extension legs 5 together. Fasten
with the screws 2 supplied (if necessary a