Silvercrest SHTR 2200 D2 - Handbuch (Seite 9)

7 GB
Styling attachment
The styling attachment 12 makes it possible
to direct the air flow onto specific sections of
hair.
1. Place the styling attachment 12 onto
the front of the hair dryer, so that it
locks into position.
2. The styling attachment 12 can be rotat-
ed into any position desired.
3. Do not remove the styling attachment 12
from the hair dryer until it has cooled
down.
Diffuser
Use the diffuser attachment 13 to create
curls and gentle waves in the lengths and
tips, as well as for body and volume at the
roots of the hair.
1. Figure A: Place the diffuser 13 onto
the hair dryer.
2. Switch on the hair dryer.
3. Use:
- For long hair: draw diffuser 13
through to the tips, and style the hair
into gentle waves in the direction of the
roots.
- For short hair: use the diffuser 13 to
work on the hair around the roots, gen-
erating body and volume.
4. Do not remove the diffuser 13 from the
hair dryer until it has cooled down.
6. Cleaning
DANGER!
~ Pull the mains plug 5 out of the wall
socket before you clean the hair dryer.
WARNING! Risk of material damage!
~ Do not use any astringent or abrasive
cleaning agents.
Clean the device regularly. Particularly en-
sure that the air inlet and outlet are free of
dust, hair and fluff.
• Wipe down the casing, the protective
grid 1 over the air inlet, and the styling
attachment 12 using a damp cloth.
• Remove the styling attachment 12 or the
diffuser 13 from the hair dryer. Hold the
hair dryer with the air outlet 11 pointing
downwards. Clean the protective discs
using a brush.
Cleaning the protective grid
1. Squeeze the protective grid 1 slightly
at the sides and then remove it.
2. Remove the filter 3.
3. Hold the hair dryer with the air inlet
pointing downwards. Clean the inside
and the outside of the protective grid
and the filter 3 using a brush.
4. Replace the filter 3 and the protective
grid 1.
Cleaning the attachments
1. Do not remove an attachment (12 or
13) from the hair dryer until it has
cooled down.
2. Wipe the attachment (12 or13) with a
damp cloth.
3. Allow the attachment (12 or13) to dry
completely before you use it again.
7. Storage
WARNING! Risk of material damage!
Do not wrap the cable around the device
(risk of cable damage!).
• You can use the hook loop 6 to safely
and practically hang up the device for
storage purposes.
__KRA102826_B6.book Seite 7 Mittwoch, 10. September 2014 5:58 17