Silvercrest Z31281 - Handbuch (Seite 8)

8 GB/IE
Installation / Bringing into use / Operation
the housing by sliding it downwards (Fig. A).
2. Mount the wall bracket 10 vertically in the
desired position on the wall with the sup-
plied screws 7 and dowels 6 .
Note: The supplied dowels are intended for
use in ordinary solid masonry. Seek expert
advice on suitable fixings if the device is to
be fixed to another type of wall construction.
3. Pull the separation strip out of the battery
compartment 8 .
4. Then mount the scale on to the wall bracket 10 .
Note: Measuring accuracy may be detri-
mentally affected if the device is not in-
stalled vertically.
Q
Bringing into use
Q
Setting the time
j Press the MODE / + button 5 until the
device enters the clock mode.
j Press the SET / WEIGHT MODE button 3
to enter the settings mode. The minute dis-
play value flashes.
j You can use the MODE / + button 5 or the
Digital timer / UNIT / Alarm / - button 4
to set the value.
Note: If you keep these buttons 4 , 5
pressed, you can accelerate the process
and reach the desired value more quickly.
j Press the SET / WEIGHT MODE button 3
to store the set value and move on to setting
the hour display value. The hour value flashes.
j You can use the MODE / + button 5 or the
Digital timer / UNIT / Alarm / - button 4 to
set the value.
j Press the SET / WEIGHT MODE button 3
to store the set value and leave the settings
mode.
Note: If no key is pressed within 10 seconds,
the set value will stop flashing and the time
is set to the value shown in the display.
Q
Operation
The device has five functions:
1. Time display
2. Weighing
3. Temperature display
4. Alarm function
5. Digital countdown timer
j You can switch between the various func-
tions by pressing the MODE / + button 5 .
Q
Using the time display
j Press the MODE / + button 5 until the de-
vice enters the clock mode.
j The display shows the time (hours:minutes).
j If you wish to change the time to another
value, proceed as described in the section
“Setting the time”.
Note: The device continues to show the
time unless the device is switched to anoth-
er function by you pressing the MODE /
+ button 5 .
Q
Using the scale
Note: When using this product as a tabletop
unit, make sure it is placed on a solid and flat
surface for the weighing process.
j Fold down the glass plate 9 .
j Place the weighing bowl 1 on the device’s
weighing platform.
j If necessary press the MODE / + button
5 until the device enters the weighing
mode. This comes after the time display.
j You can press the SET / WEIGHT MODE
button 3 to switch between the weighing
mode settings for weight 17 , water 16 and
milk 15 . The selected weighing mode set-
ting is indicated by a small bar indicator in
the display.
75609 CB3_GB_DK.indd 8 7/5/2012 8:47:30 AM