Silvercrest STV 45 C2 - Handbuch (Seite 9)

7
Notes
– On delivery, screw ring 12 is screwed
onto the bottom of the tower fan.
– Ensure that power supply cable 9 is
located in the depression provided for it.
– Tighten screw ring 12 hand-tight. Do
not use a tool.
6. Select a location in line with the safety
instructions (see “4. Safety instructions”
on page 4).
7. Plug the power plug into a power supply
socket which meets the technical data
requirements.
6. Operation
6.1 Start and switch off the appliance
1. Plug the power plug into a power supply
socket which meets the technical data
requirements (see “3. Technical data”
on page 4).
2. Switch on the power
supply by turning rotary
switch 2 to "ON".
The appliance is now operational.
3. Switch off the power
supply by turning rotary
switch 2 to "OFF".
6.2 Set blower setting
The blower settings are used to select how
fast the appliance circulates air in the room.
The appliance has three blower settings:
– 1, low: press button 6;
– 2, moderate: press button 4;
– 3, high: press button 3.
Press the 7 "OFF" button to stop the
appliance working.
6.3 Set running time
The appliance has a timer which you can
use to set the desired running time to
between 0 and 120 minutes.
1. Switch on the timer by
turning rotary switch 2 to
any time between 0 and
120 minutes. The power
supply is switched on at
the same time.
2. To switch off the timer, set rotary
switch 2 to "OFF".
Note If you want the appliance to operate
continuously, set rotary switch 2 to "ON".
RP103879 Tower-Ventilator LB6so Seite 7 Mittwoch, 1. Oktober 2014 11:26 11