Silvercrest SZP 25 B1 - Handbuch (Seite 8)

6 GB
juicer cone2/3 starts turning, and the
juice flows into the juice container7.
3. As soon as you stop pressing on the
juicer cone2/3, the device stops.
4. If the juicer cone2/3 is not turning,
check if there are pips between the juic-
er cone and the screen4/5 and re-
move them, if necessary.
6.3 Removing the juice
CAUTION: pull out the mains plug11 be-
fore removing the juice container7 from the
base9.
1. Figure B: turn the juice container7
counterclockwise and lift it from the
base9.
2. Pour the juice out of the juice container7.
3. In order to remove pulp and pips, you
can remove the screens4/5 and the
juicer cone2/3 together with the juice
container7.
4. Clean the device after each use as soon
as possible so the pulp does not start
drying to the surface.
7. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
• Pull out the mains plug11 from the wall
socket before cleaning the citrus press.
• The base9, the power cable and the
mains plug11 must not be immersed in
water or any other liquids.
WARNING!
• Do not clean the citrus press or any of
its accessories in the dishwasher or with
boiling hot water.
• Do not use any astringent or abrasive
cleaning agents.
NOTE: clean the device after each use as
soon as possible so the pulp does not start
drying to the surface.
1. Remove the lid1, if necessary.
2. Remove the juicer cones2/3 and disas-
semble them.
3. Remove the screens4/5.
4. Figure A: in order to disassemble the
screens4/5, exert slight pressure on
the screen opener6.
5. Figure B: turn the juice container7
counterclockwise and lift it from the
base9.
6. Wipe the base9 with a damp cloth.
7. Wash up all removable accessories by
hand. Make sure to wash the small cavi-
ty in the handle with a sufficient amount
of clear water.
8. Dry all parts carefully, before reassem-
bling the device and storing it.
8. Storage
1. You can wind up the power cable11 in
the cable wrap10. Secure the power ca-
ble behind the mains plug with clamp10.
2. Place the lid1 on the device as a pro-
tection against dust. Ensure that the re-
cess in the edge of the lid is above the
handle.
9. Disposal
The symbol showing a wheelie
bin crossed through indicates
that the product requires sepa-
rate refuse collection in the Eu-
ropean Union. This applies to
the product and all accessories
marked with this symbol. Prod-
ucts identified with this symbol may not be dis-
carded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Recy-
cling helps to reduce the consumption of raw
materials and protect the environment.
__RP96254_B6.book Seite 6 Mittwoch, 27. November 2013 1:36 13