Powerfix Z22855 - Handbuch (Seite 6)

GB/IE 8

Wear protective gloves! If they come into contact
with skin, leaked or damaged batteries could cause chemi-
cal burns; you should therefore wear suitable protective
gloves at all times if such an event occurs.

Avoid contact with skin, eyes, and mucous membranes. If
you come into contact with battery acid, rinse the affected
spot with plenty of water and / or consult a doctor immedi-
ately!

WARNING! Switch the product OFF before inserting
the battery (LCD display 5 is off.)

Remove the battery from the device if it is not in use for a
long period of time.

Do not, on any account, short-circuit the terminals.
 Before start of operation
 Insert / replace battery
Tip: Flashing numbers indicate a discharged / flat battery.
Tip: When changing the battery, the LCD display
5 may
experience faults. Remove the battery and insert it again after
waiting more then 30 seconds.

Push open the lid to the battery compartment 8 (see Fig. B).

Remove the old battery.

Insert the new battery into the battery compartment and
ensure correct polarity (+ and -). Make sure that the plus
terminal points outwards.

Push the lid to the battery compartment 8 shut again
(see Fig. B).
 Preparing the ca

Loosen the locking screw 4 so that you can move the

Clean all measuring surfaces and the
99999999999 9rod. Otherwise,
faulty measuring results may occur due to, for example,
humidity.

Check that all keys, switches and the LCD display 5 work
correctly.
 Starting up the device


Loosen the locking screw 4 by turning it anti-clockwise.

Push the external measuring jaws 11 and the internal meas-
uring jaws 2 together.

Switch the LCD display 5 on by pressing the ON / OFF key 10 .
alliperJ
alliper
 Using the ca
ůů
iper
ůů
iper