Gardena C 1030 plus Art. 1862 - Handbuch (Seite 8)

8
GB
The Prog ON must be selected so that the watering programme
can start.
1. Press the Menu button 5 times (not necessary if the
programme has been created before).
2. Select the Prog ON with the rotary button and confirm by
pressing OK.
The Prog OK appears for 2 seconds and then the Normal
display returns.
The water computer has now been programmed, i.e. the inbuilt
valve opens and closes completely automatically and thus waters
at the programmed time.
Even if Prog OFF is selected watering can be done manually.
Soil moisture sensor-controlled watering
Condition : the GARDENA Soil Moisture Sensor Art. 1188 is
connected.
A previously set scheduled watering programme is retained but
not carried out.
1. Hold the Menu button down for 5 seconds. The watering cycle
flashes.
2. Select the required watering cycle with the rotary button
(e.g. Day) and confirm with the OK-key.
Day Watering during the day (6 a.m. – 8 p.m.) when
the soil moisture sensor registers dry.
Night Watering during the night (8 p.m. – 6 a.m.) when
the soil moisture sensor registers dry.
Day & Night Watering when the soil moisture sensor registers dry.
3. Set the watering duration in minutes (0 – 59 minutes) with the
rotary button (E.g. 40 minutes) and confirm by pressing OK.
Watering starts in the set watering cycle as soon as the soil
moisture sensor registers dry (Sensor ON).
The watering duration set in the sensor-controlled watering mode
also applies to manual watering.
In the case of soil moisture sensor-controlled watering, a
two hour watering pause is triggered after every watering
cycle in order for the soil moisture sensor to record the soil
moisture.
Example :
Watering cycle = (Day),
watering duration = 40 minutes.
Watering begins when the sensor registers dry (Sensor ON)
during the day (between 6 a.m. and 8 p.m.) and ends up to
40 minutes later depending on the amount of moisture in the soil.
Starting watering
programmes :
[Level 6]