Metz 20 TK 51 - Handbuch (Seite 54)

- 52 -
After the setting time of sleep timer has
passed then TV goes automatically to stand-
by.
 
Mute Indicator
It is placed in the upper middle of the screen
when enabled, and it stays there until it is
disabled.
To cancel mute, there is two alternative; the
first one is pressing to " " button, this vol-
ume is set to the preceding value, and the
second one is increasing the volume level,
thus it starts at the minimum level to in-
crease. By decreasing the volume level in
mute state, mute will not be ignored, only the
volume level will decrease. If mute canceled
after decreasing the volume level, the vol-
ume will valid with the decreased level.
No-Signal Detection (TV)
If no valid signal detected, it takes 5 minutes
for the switching to the Stand-By mode un-
less any signal detected or no any Remote
Control command is accessed.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal detected again the timer is initialized
to 5 minutes and starts 3 seconds later
again to count down.
It is not valid in AV mode.
 
No-Signal Detection (PC)
If no valid signal detected for 5 minutes sys-
tem goes to Stand-By mode. To switch on
the system press “ ” button.
As the last status feature, system starts from
TV or PC, whichever was the status before
stand-by or switch-off. Note that SCART in-
puts have the precedence on both TV and
PC.
Volume Bar
It is displayed in the lower middle of the
screen. When a volume command is re-
ceived (pressing “
+” or “ -” by Re-
mote Control or Control panel at the top of
the TV) and no menu is active, it stays on the
screen for 3 seconds, after the last volume
command or until another command is re-
ceived in between.
AV Modes
By pressing the “AV“ button you can switch
your TV to AV modes (except being in Tele-
text). Pressing this button will consecutively
switch the TV in one of the optional AV
modes: AV-1, AV-2, AV-3, S-VIDEO, PC.
In order to quit the AV mode press the “TV”,
digit buttons or “P-” or “P+” .
Signal Out Of Range
When the PC input signal is not supported
by LCD-TFT TV, a message is displayed like
“Signal out of range” and screen is blanked.
PC MODE
Installation
• Power off both Computer and Display before
making any connections.
• The monitor comes with a 15-pin PC cable.
Connect end of the signal cable to the 15-
pin connector on the rear of the Computer.
$ÃQvÃHvvÃ9TˆiÃ8‚rp‡‚
• Tighten the screws of the Display cable until
the connectors are fastened securely (fin-
ger-tighten only).