Preparing for use, Switching on and off, Setting the cutting angle – Kompernass PHKS 1450 LASER Benutzerhandbuch

Seite 11: Setting the cutting depth, Setting the guide fence, Switching the laser on and off, Working with the circular saw, Setting the speed

Advertising
background image

13

GB/IE/CY

Q

Switching on and off

Switching on:

j

Press the safety lock-out

2

to the left or right

and keep it pressed.

j

Press the ON / OFF switch

8

. Once the saw

is running you can release the safety lock-out
again.

The circular saw is fitted with an

electronic soft start system.

The motor starts with a delay.

Switching off:

j

Release the ON / OFF switch

8

.

Q

Setting the cutting angle

You can set the cutting angle accurately with the
help of the cutting angle scale.

j

Release the wing screws of the cutting angle

setting clamp

4

on both sides, set the desired

angle on the scale and retighten the wing
screws.

Q

Setting the cutting depth

Note: If possible we recommend that the cutting
depth is set approximately 3 mm greater than the
material thickness. This should help to ensure you
achieve a clean cut.

j

Release the wing screw on the cutting depth

setting clamp

5

, set the required cutting depth

on the scale

15

and retighten the wing screw.

Q

Setting the guide fence

j

Release the wing screw

10

of the base plate

7

and insert the guide fence

12

into the slot

11

.

Retighten the wing screw

10

.

Q

Switching the laser on and off

Switching on:

j

Move the laser ON/OFF switch

14

to setting “I”.

Switching off:

j

Move the laser ON/OFF switch

14

to setting “0”.

Note: If the batteries become exhausted you should
replace them with two new ones, type AAA 1.5 V.

Q

Working with the circular saw

1. Switch on the device as described in the

section about “Switching on and off” and then
place it first with the front edge of the base
plate

7

against the material.

2. Align the device using the guide fence

12

or

with reference to marked-out line or by using
the laser.

3. Saw with a even pressure whilst holding the

device by the handles with both hands
(see Fig. A).

Q

Setting the speed

j

Turn the wheel

1

to the desired speed setting

(arrow marking

G)

(1 = lowest speed / 6 = highest speed):

Use the general settings suggested in the following
table (information offered without liability) or adjust
the speed setting on the setting wheel

1

to the

material being cut.

Material

Speed setting

Hard- and softwood (solid wood) cut
longitudinally and transversely

6

Plywood, hard fibre board

6

Chipboard

6

Blockboard, laminated wood

6

Coated and veneered board

6

PVC board

3-5

Preparing for use

Advertising