Auto setup – Lenovo T545 Benutzerhandbuch

Seite 20

Advertising
background image

8

When you first use your monitor you must perform Auto Setup. This procedure
sets up your monitor to process the video signals from your computer without
image discoloration or smearing. After you perform Auto Setup, the settings are
stored and used each time you turn on the monitor.

In order to optimise the displayed image a set-up utility is provided on the
IBM Monitor Installation Diskette. Operation of this utility is dependent on the
operating system on your computer. For correct operation locate the operating
system on your computer from the table below and follow the appropriate
instructions. You may choose to run AUTO SETUP for each operating system
that you use. This means that if you sometimes use your monitor while running
any version of Windows and sometimes also use it from within DOS (not a DOS
window), you must run AUTO SETUP for both Windows and DOS. You may run
versions of AUTO SETUP in any order.

Before you begin AUTO SETUP for your computer:

1. Make a backup copy of the setup diskettes supplied with the monitor.

2. Make sure the computer video mode is set in the range of the

supported screen resolution shown in the table on page18.

You should perform AUTO SETUP for each screen mode you use.

Auto Setup

Before carrying out this
section, it is very important
that The Setup Diskette for
Windows 95 or Windows 98
has been run.(see page6)

i

The Setup Utility included
on the setup diskette is for

displaying dot patterns. They
do not replace or modify the
display driver.

i

The Auto Setup
instructions require the

monitor to be warmed up for 15
minutes. This is not required
for normal operation.

i

By pressing the

and

keys simultaneously allows

direct access to the auto set-up
controls.

i

If your computer does not
run with the setup

diskettes shipped with the
monitor, refer to Manual Setup
on page 12

i

The AUTO SETUP process
only applies to the current

screen mode. When a new
mode is selected, repeat this
section to reset the monitor.

Operating System

DOS

Auto Setup for DOS on page 9

Auto Setup Microsoft Windows 3.1,

Windows 95, Windows 98, Windows 2000

or Microsoft Windows NT 4.0 workstation

on page 10

Microsoft Windows 3.1

Microsoft Windows 95

Microsoft Windows 98

Microsoft Windows 2000

Microsoft Windows NT 4.0
workstation

Corresponding Auto Setup procedure

Auto Setup

Advertising