Eizo FlexScan L760T-C - Handbuch (Seite 17)

English
NOTE
• Whenever finished, turn off the PC and the monitor. Disconnecting the monitor
from the power supply is recommended to save energy completely.
• Adjust brightness of the screen depending on the brightness of your environment.
Too dark or too bright of a screen can cause eyestrain.
• Be sure to take adequate rests. A 10-minute rest period each hour is suggested.
2-3. Touch Operation
Point and touch with one finger only.
NOTE
• Do not touch the screen while turning on the PC and the monitor. Touch the screen
one second later after appearing the image.
• For the users with gloves, we recommend to use touch panel pointer, “TP1”
(optional). Regarding the installation, please refer to the User’s Manual of TP1.
2-4. Connecting two PCs to the monitor
Two PCs can be connected to the monitor through the DVI and the D-Sub mini 15 pin
connector on the back of the monitor.
Selecting the active input
The Input Signal Selection Button on the control panel can be used to select either Signal
1 or Signal 2 as the active input at any time. Every time the button is pressed, the input
changes. When switching the signal, the kind of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
ENTER AUTO
SIGNAL
1 - 2
MODE
Input Signal Selection Button
2. CABLE CONNECTION
15