Eizo FlexScan L760T-C - Handbuch (Seite 31)

English
Problems Points to check with possible solutions
14. Cursor position is not correct. /
Cursor jumps.
When cursor position is incorrect or cursor
jumps, turn off and on the monitor. If the
symptom is not improved, perform the
calibration on the monitor.
• Do not touch the screen while turning on the
PC and the monitor. Touch the screen one
second later after appearing the image.
• Changing the position or angle of the
monitor will cause cursor jump.
The drawing touch and dragging the fi nger on
the touch panel to draw the picture may cause
incorrect cursor position.
Keep metals away from the panel surface.
Touch with one finger only. Keep other fingers
away from the touch screen. Do not rest the
hand in the monitor or bezel while touching the
screen.
The spray for preventing static electricity may
infl uences the sensibility of the touch panel. Do
not use it on cleaning.
15. Continuous touch sound./
Much time requirement for
executing touch screen
calibration or cursor stabilization.
Check the baud rate for the touch panel on
TouchWare. The baud rate of 1200 bps may
cause continuous touch sound or much time
requirement for executing touch screen
calibration or cursor stabilization.
16. No touch sound. The touch sound may not be output from the
external line out of the PC depending on the
hardware configuration.
6. TROUBLESHOOTING
29