NEC 200 - Handbuch (Seite 14)

Connection to your Personal Computer (Macintosh)
With the Macintosh cable adapter, the MultiSync LCD 200 color monitor
is compatible with the Macintosh family of computers, Power
Macintosh, Mac Quadra Series, Mac Centris Series, Mac LC series,
Mac Performa series, PowerBooks and other NuBus/PCI display cards
@ 640x480, 800x600, and 1024x768 resolutions.
You will connect your MultiSync color monitor one of two ways to
your Macintosh computer:
– On-board video port
– NuBus/PCI/PDS display card
Both configurations should have the same style video connector. If you
are not sure which port is the monitor connector, please reference your
computer or display card manual.
To attach the monitor to your system, follow these instructions:
1. Turn off the power to your MultiSync monitor and Macintosh.
2. If necessary, install the display card. For more information on
this installation, reference the display card manual.
3. If necessary, install the 15-pin to 15-pin MultiSync LCD 200
Macintosh cable adapter to the monitor connector. Tighten the
screws.
4. Connect the MultiSync monitor’s signal cable to the other end
of the cable adapter. Tighten the screws between the signal
cable and cable adapter to ensure proper connection.
5. Connect one end of the power cable to the MultiSync monitor
and the other end to the power outlet.
6. If you have a Powerbook, Mac LC, Mac AV, Power Mac or
Quadra 605 or 630 or are running system 7.5, please make sure
the SYNC switch is in the ON position. (The SYNC switch is
located on the back of the monitor). All other Mac systems
require the SYNC switch to be in the OFF position.
7. Turn on the monitor and the computer.
Installation E - 9