NEC 200 - Handbuch (Seite 15)

8. This completes the installation.
Power Macintosh 6100/60 and 66 users need to use the Apple HDI-45
cable adapter and Powerbook users need to use the Apple VID-14 cable
adapter in conjunction with the appropriate MultiSync Macintosh cable
adapter when connecting a MultiSync monitor.
Connection to Other Computers or Display Cards
If your computer or display card is not compatible with the MultiSync
LCD
200 color monitor’s PRESET signals or has a different pin
assignment, refer to the steps below to determine if your system is
compatible with the MultiSync LCD
200 color monitor.
1. Determine the video connector’s pin assignments of your
display card.
2. Determine the output signal timing and level of your display card.
3. Check the pin assignment and signal timing charts of the display
card and make sure the monitor accepts these pin assignments
and signal timings.
4. Select the appropriate SYNC switch setting on the rear of the
monitor according to your computer or display card output.
SYNC switch should be set in the ON position for standard
separate or composite Sync mode and in the OFF position for
Sync on Green priority mode.
5. Connect the signal cable supplied with your display card to the
monitor.
6. Connect one end of the power cable to the MultiSync LCD 200
monitor and the other end to the power outlet.
7. Turn on the monitor and the computer.
8. Adjust the position of the image to your preference.
9. This completes the installation.
If you have any problems, please refer to the Troubleshooting section of
this manual.
E - 10 Installation