AEG 47056IU-MN - Handbuch (Seite 34)

Problem Possible cause Remedy
come on There is an error in the
appliance, because a
cookware boils dry or
you use not correct
cookware. Overheating
protection for the cook-
ing zone operates. The
automatic switch-off op-
erates Switch off the appliance.
Remove the hot cook-
ware. After approximate-
ly 30 seconds switch on
the cooking zone again.
should disappear,
residual heat indicator
can stay. Cool down the
cookware and check it
with the section Cook-
ware for the induction
cooking zone
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre. The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
14. INSTALLATION
WARNING!
Refer to "Safety information"
chapter.
Dimensions
Height 847 - 867 mm
Width 596 mm
Depth 600 mm
Oven capacity 74 l
Voltage 230 V
Frequency 50 Hz
14.1 Location of the appliance
You can install your freestanding appli-
ance with cabinets on one or two sides
and in the corner.
A
A
B
Minimum distances
Dimen-
sion
mm
A 2
B 685
14.2 Levelling
Use small feet on the bottom of appli-
ance to set the appliance top surface
level with other surfaces.
34 www.aeg.com