AEG SKZ81800F0 - Handbuch (Seite 30)

Problem Possible cause Solution
The compressor
does not start imme-
diately after press-
ing the COOLMATIC
switch, or after
changing the tem-
perature. This is normal, no error
has occurred. The compressor starts af-
ter a period of time.
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
The temperature in
the appliance is too
low/high. The temperature regula-
tor is not set correctly. Set a higher/lower temper-
ature.
The door is not closed
correctly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
Upper or lower
square is shown in
the temperature Dis-
play. An error has occurred in
measuring the tempera-
ture Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
dEMo appears on
the Display. The appliance is in dem-
onstration mode (dEMo). Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly
6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
30 www.aeg.com