Xoro HRS 8525 - Handbuch (Seite 53)

HRS 8525 ENG 15
Engl
ish
Connection
A coaxial cable is necessary for the S/PDIF signals for the digital connection to a Hi-Fi system. This
cable is not included in the delivery of this receiver. Connect the S/PDIF out put with the S/PDIF
input of your Hi– Fi system. Please refer to the manual of the Hi-Fi system to select the audio input.
Notes:
The HRS8525 could out put digital signals in PCM-(stereo) or AC3– Bitstream (Dolby Digital). If your
Hi-Fi system provides no sound for programs with Dolby Digital sound track, please refer to page 34
to change the out put format of the S/P DIF out put.
The USB port is on the front side of the HRS8525. It takes the receiver under circumstances some
time to recognize the USB and get ready for further operation.
Please remove the USB storage only after all recording or playback processes are completed.
Following USB devices will be supported:
•
USB storage
• Max. capacity 320 GB
• File system: FAT 16, FAT32, NTFS
Notes:
•
There are a variety of USB storages on the market. Not all of them conform the specification
of USB storage. If your USB storage could not be read by HRS8525, please try another USB
storage.
• If a USB device could not be read any more, please carry out a data storage medium analysis
with your computer or format the storage again.
• USB storages requiring higher electric current than 500mA (0,5A) do not conform the
specification of USB storage. These USB storage could possibly not work smoothly together
with HRS8525.
• USB Storage up to 320GB will be supported. USB storage of larger capacity could also be
used. However the capability of these USB storages with HRS8525 could not be guaranteed.
• Please always save all data on the USB before connection to the HRS8525.
• A sufficient writing– and reading speed of the USB storage is necessary for recording HD
programs or use the Time-Shift function. In case of problems in recording or Time-Shift,
please try a USB storage of higher writing– and reading speed.
Connection to satellite dish
connection to a Hi- Fi system
Connect the cable of your satellite dish to the Antenna input LNB IN
of the HRS8525.
Notes:
•
Screw the so-called F plug together with the LNB IN.
• Please make sure to avoid short circuit at the F plug.
• Employ only high quality antenna cables. Low quality antenna cables might cause
disturbance.
You can connect further satellite receivers onto the LNB out. We recommend it only to technically
experienced users, for the receivers connected this way affect each other and do not share the
complete program accessable to both receives.
Connecting to USB storage