Xoro HRS 3400 - Handbuch (Seite 68)

16 HRS 3400
Engl
ish
A new window appears on the screen with
the parameters and settings of the satellite.
Please pay attention that the LNB Type is
made on Universal.
LNB Type
The options are:
Normal C
Searching by analogue TV
channels in low frequencies
Normal Cu Searching by analogue TV
channels in low frequencies
Universal Searching for analogue and
digital TV channels
LNB Low and High Frequency
By using the settings of LNB Type the low and high frequencies are set automatically.
22K Tone
By using the LNB Type Universal the setting for 22k Tone is set automatically to AUTO. This
setting is responsible to find analogue and digital TV channels.
By using the 22-kHz signal in conjunction with a universal LNB is the entire Astra satellite
system to receive (analogue and digital) with a single 60cm antenna. To receive digital TV
and radio signals will therefore only one set-top box for digital television, are required.
LNB Power
The LNB needs for receiving digital TV channels a power of 13 V and 18V. Please use the
setting 13/18V, otherwise not all TV channels can be found.
In case of LNB Power is Off, the LNB do not get any power from the satellite receiver and no
channels can be found and received.
Transponder
This setting needs normally no changes.
Transponders are used in principle to a signal that comes from an earth station to a satellite
prepare, so that the end-user (TV, telephone, computer), the optimum signal sent and re-
ceived can be recovered. A transponder is working on the whole as a kind of amplifiers and
frequency converters. It receives multiple signals at a certain frequency from an earth sta-
tion, amplifies these filters out interference, put it into another (the receiver dependent) fre-
quency levels increased again and sends the signals back to Earth.
First Time Installation
My Dish - Single Connection