Burkert Type 8644 - Handbuch (Seite 5)

ENGLISH Change of function of DIP switch 8 and actions for customers
Identity-Number: 805038
page 5 of 8
Addendum Type 8644 / ME02 – PROFIBUS-bus terminal
Change of function of DIP switch 8 and actions for customers
Hardware Configuration
Configure the hardware on the PROFIBUS-bus terminal using the 10-pos. DIP switch.
Figure 1: DIP switches of the PROFIBUS-bus terminal
The PROFIBUS address and other PROFIBUS-bus terminal settings can be set using the 10-pos. DIP switch.
The function of the switches can be found in Table 1.
Table 1: DIP switch settings on the PROFIBUS-bus terminal as of serial number 37344
DIP Switches Meaning
1 to 7 PROFIBUS address in binary format ( = 0 – 127 in decimal format):
switch 1 defines the least significant bit (LSB) (2 0 );
switch 7 defines the most significant bit (MSB) (2 6 )
8 Inline station operation mode:
On = New mode with DP/V1 support, failsafe values and parameterisation;
Off = Compatible mode (to PROFIBUS-bus terminal till serial number 37343)
9 to 10 Reserved for service functions;
both switches must be in „OFF“ position