WolfVision VZ-C3D Installation - Handbuch (Seite 10)

9
The Visualizer can be finely-adjusted if necessary.
By loosening all three hex nuts the unit can be turned by 15 degrees to the left or right (please make sure
that all three hex nuts are tightened after re-adjustment). The Visualizer can also be moved backwards or
forwards +/- 10mm (0.39") by loosening the three mounting plate hex nuts on the steel anchors (please
make sure that the mounting plate hex nuts are tightened again after re-adjustment).
+/- 15°
+/- 10mm