WolfVision VZ-8light - Handbuch (Seite 4)

The RGBHV-output (#12) can output signals in the following formats:
- XGA (1024x768 pixel) at 75Hz
- XGA (1024x768 pixel) at 60Hz
XGA (1024x768) at 60 Hz.
If you output the Visualizer image on a CRT-monitor or CRT-projector, use an output mode
with 75Hz, because 60Hz may show a slight image flickering. For LCD/DLP projectors or
monitors and video conferencing units 60Hz is the best choice. If you are unsure what is the
best mode read the user manual of the connected units.
You can change the output mode in the on-screen-menu of the Visulizer (see page 5).
.
The default setting is
Choosing the right output mode
(XGA at 75Hz or 60Hz)
3
USB-PORT
The USB output of the VZ-8light can be used to transfer
Visualizer images onto a computer in just 2 seconds. No
additional computer hardware (like a grabber card) is required. In
this way the Visualizer can be used as a 3-D scanner for your
computer. Just connect the USB port (#13) of the Visualizer and
the USB port of your computer, using the supplied USB cable.
A dedicated WolfVision USB-software can be downloaded from WolfVision's Internet
homepage at: www.wolfvision.com/wolf/techinfo.html. The software works under Windows
98, ME, 2000 and XP. Windows 95 and NT will not work, because they do not support USB.
EXTERNAL INPUT
A Computer can be connected to the External RGBHV input (#11) of the Visualizer.
Press the Power-key (#5) for 2 seconds to switch between the Visualizer and
Computer image to be displayed to the audience.
The signal from the computer is just looped through the Visualizer and is not processed
in any way. In order to avoid that your projector or monitor adjusts itself when switching,
it is recommended that you set the output of the computer to the same signal format
(XGA) and vertical frequency (75 or 60Hz) as the Visualizer. The default
output settings of the Visualizer is: XGA (1024x768) at 60Hz.
Connect the power cord to the light box connector (#16) on the back side of the Visualizer.
The light switch (#6) of the Visualizer can now be used to switch between the light of the
Visualizer and the light of the lightbox.
WolfVision lightboxes (optional)
Other lightboxes:
In order to prevent reflections the light of the Visualizer always has to be switched off when
working with lightboxes.