WolfVision VZ-8light - Handbuch (Seite 5)

Autofocus:
When switching on the unit the autofocus is automatically switched on too. The correct focus is
continuously adjusted. The green light beside the autofocus on/off switch (#9) is illuminated if
the autofocus is on.
Please note that objects with a very low contrast (like a blank sheet of paper) are difficult to
focus. If the autofocus does not work just move the object slightly.
For special applications the autofocus can also be switched off using the AF on/off switch (#9).
The autofocus is also switched off when the manual Focus are used (see manual focusing).
Manual focusing
For manual focusing press AF-key (#9) (hold it down) and focus with the zoom keys (#10).
Shooting area on the working surface:
Eliminating reflections
In order to eliminate reflections (on high gloss photographs etc.)
just turn the light backwards slightly.
Please note that reflections can also be caused by the room light.
4
Shooting area outside of the working surface:
Turning the light backwards
In order to enable recordings with
illumination outside of the working
surface, the light of the Visualizer
can be horizontally turned an
angle of up to 250 degrees.
to infinity
Close-up adaptor lens
For shooting an object outside the working surface, in a further distance to the unit, the close up
lens (#7) has to be removed.
In this case just pull the lens away from the main optic Of the camera until it reaches the locked
position. It is impossible to remove the lens completely from the unit, therefore it can not get
lost. Before turning back the camera into the standard working position push the close up lens
back in.