Electrolux EOR5821BAX - Handbuch (Seite 29)

Installing the door and the glass
panels
When the oven door is clean, install the
glass panels in the opposite sequence.
Make sure that you put the glass panels
back in the correct order.
The middle glass panels have a graphic
located on the top. The third glass panel
has screen printings. In others, it is trans-
parent.
The screen-printing zone must face the
inner side of the door. Make sure that af-
ter the installation the surface of the glass
panel frame is not rough when you touch
it.
13. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does
not heat up. The appliance is deactiva-
ted. Activate the appliance.
The appliance does
not heat up. The clock is not set. Set the clock.
The appliance does
not heat up. The necessary settings are
not set. Make sure that the settings
are correct.
The appliance does
not heat up. The Child Lock is activated. Refer to "Deactivating the
Child Lock".
The appliance does
not heat up. The fuse is released. Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact an
authorized electrician.
There is water inside
the appliance. There is too much water in
the tank. Deactivate the appliance
and remove the water with a
cloth or sponge.
The steam cooking
does not operate. There is no water in the
tank. Fill the water tank.
The steam cooking
does not operate. Lime obstructs the hole. Check the steam inlet open-
ing. Remove the lime.
It takes more than
three minutes to
empty the water
tank or the water
leaks from the
steam inlet opening. There are lime deposits in
the appliance. Check the water tank. Refer
to “Cleaning the water
tank”.
ENGLISH 29