Electrolux EOR5821BAX - Handbuch (Seite 30)

Problem Possible cause Remedy
Steam and conden-
sation settle on the
food and in the ap-
pliance. You left the dish in the appli-
ance for too long. Do not keep the dishes in
the appliance for longer
than 15 — 20 minutes after
the cooking ends.
The display shows
F111. You did not correctly install
the CT Sensor into the
socket. Put the plug of core temper-
ature sensor as far as possi-
ble into the socket.
The lamp does not
operate. The lamp is defective. Replace the lamp.
The display shows
“Demo”. The appli-
ance does not heat
up. The fan does
not operate. The test mode is activated. 1. Deactivate the appli-
ance.
2. Touch and hold until
the appliance activates
and deactivates. The
sensor field is illumina-
ted.
3. Touch and hold and
at the same time un-
til an acoustic signal
sounds and the sensor
field is off. “Demo” goes
out.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre. The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
14. TECHNICAL DATA
Voltage 230 V
Frequency 50 Hz
15. INSTALLATION
WARNING!
Refer to the Safety chapters.
30 www.electrolux.com