ROTHENBERGER ROWELD P 125 115V Benutzerhandbuch
Seite 14
12
ENGLISH
2
Technical data
Mains voltage............................. 230V AC
Current ...................................... 5,7 A
Max. output ............................... 1300 W
Mains frequency......................... 50/60 Hz
Working range ........................... 16-125mm
Temperature range..................... 160-280°C
Dimensions ................................ 500x200x65mm
Weight ....................................... 3,1 kg
3
Function of the unit
3.1
Overview (fig. A)
1
Isolated Handle
6
Switch (green with Lamp)
2
Flex with Plug
7
Heating plate
3
Temperature adjusting Knob
8
Heating jack
4
Temperature Scale
9
Heating arbours
5
Control lamp
10
Counter pin
The handy pipe socket welding machines are designed fort he overlap welding of PE, PP and
PVDF plastic pipes and shaped pieces in a workshop and on sites.
There are two methods of welding: type A und type B.
Using method A the pipe is used without peeling, it is simply chamfered.
Using method B the pipe must be peeled to a certain length and then chamfered.
The ROTHENBERGER heating jacks (8) and -arbours (9) are designed in form A and are marked
accordingly on the uncoated rear.
3.2
Operating
instructions
The Heating Element must be used by well trained and autorized operators only!
3.2.1 Putting into operation
Please read the operating- and safety-instructions attentively before putting the
heating element into operation!
Do not use the heating element in explosive environments or bring it into
contact with easily flammable materials!
Fit the corresponding heating jacks (8) and heating arbours (9). Secure heating arbour (9) with
counter pin (10) and thighten the screw M6x40 with allen key (s.fig. A).
Insert the heating element with the mounting groove in a table clamp (no.: 5.5540) or floor
stand (no.: 5.5539).
Connect the plug to the power supply (ensure that it is the currect voltage) and move the
on/off switch (6) into the on position. The green light in the switch will be lit when the power
starts to flow.
Set the required welding temperature (pursuant to DVS 2207) of 250-270°C on the rotary
knob (3) using a screwdriver or the like.