Sony ICD-TX50 - Handbuch (Seite 112)

ModelName: ICD‑TX50
PartNumber: 4‑300‑042‑11(1)
11 11 Troubleshooting
Inde
x
Table of
Cont
ents
Continued 
Messages List
Follow the instructions below if a message appears in the display.
Message Cause/Remedy
HOLD...
Slide HOLD Switch to
Activate.
 All the button operations are disabled because the IC
recorder is in the HOLD status to prevent unintentional
operations. Slide the POWER•HOLD switch towards the
center to release the IC recorder from the HOLD status
( p. 16).
Low Battery Level
 You cannot format the memory or erase all the files in a
folder because of insufficient battery power. Charge the
battery ( p. 18).
Low Battery
 The battery is exhausted. Charge the battery ( p. 18).
Low Battery to Update
 You cannot update the firmware because of insufficient
battery power. Charge the battery ( p. 18).
microSD Card Error
 An error occurred while a microSD card was being inserted
into the microSD card slot. Remove and try inserting it
again. If this message persists, use a new microSD card.
microSD Card Not
Supported
 A microSD card that the IC recorder does not support is
inserted. See “About compatible microSD cards” ( p. 33).
Read Only microSD Card  A read‑only microSD card is inserted. A read‑only
microSD card cannot be used with the IC recorder.
microSD Card Locked
 A write‑protected microSD card is inserted. Release the
lock.
Memory Full
 The remaining memory capacity of the IC recorder is
insufficient. Erase some files before recording.
File Full
 When there are already the maximum number of files in
the selected folder or the total number of files stored on the
IC recorder has exceeded the maximum, you cannot record
a new file. Erase some files before recording.
Settings are Full
 You cannot rename a folder, since folders with the same
folder name already exist. Please select a different folder
name.
Track Marks are Full
 You cannot set a track mark, since there are already the
maximum number of track marks for a file. Cancel
unwanted track marks ( p. 61).
File Damaged
 You cannot play back or edit files, because the data of the
selected file is damaged.