BOXLIGHT MP-86i - Handbuch (Seite 12)

12
Installation
Typical LCD Projector and Screen Installation
Using the adjusters
a. Distance from the LCD projector to the screen
b. Distance from the lens center to the bottom of
the screen (a,b : +/-10%).
The projection distances shown in the diagram to
the left are for full size (800 x 600 dots).
The LCD projector should normally be used
level (the legs can point upward).
Positioning the projector sideways, or with the
lens pointing upward or downward can cause the
internal temperature to rise, which could result in
a malfunction.
Caution
Use the diagram below as reference to determine the screen size and projection distance.
• Do not release the locks unless the projector is being held; otherwise, the projector could
overturn or the fingers could get caught and cause personal injury.
• Do not force the adjusters to rotate. This could damage the adjusters or cause the lock to fail.
• Lock the adjusters firmly. If the lock is difficult to operate, change the angle slightly and try again.
Use the adjusters on the bottom to adjust the projection angle.
1. Lift up the projector and release the adjuster lock.
2. After adjusting the projection angle, firmly lock the adjusters.
3. Rotate the adjusters for fine adjustment.
Caution
Screen
Top view Side view
Lens center
Front view
Adjuster
Side view
Variable within the range of approximately 0
°
- 9
°
Screen size (inches/cm)
Minimum
a
Maximum
b (inches/cm)
40/102 55/140 73/185 1/2.5
60/152 85/216 114/290 2/5
80/203 114/290 151/384 2/5
100/254 144/366 191/485 3/8
120/305 176/447 231/587 3/8
150/381 220/559 282/716 4/10
200/508 291/739 386/980 6/15
a (inches/cm)
b
a