Lenze EL 9700 - Handbuch (Seite 82)

Mechanical installation
Mounting steps
Panel PC EL 870 / EL 1700(s) / EL 1750(s)
4
l
82 LDCDS−ELx7xx DE/EN 4.0
4.3 Mounting steps
4.3.1 Panel PC EL 870 / EL 1700(s) / EL 1750(s)
Proceed as follows for the mounting:
1. Cut the mounting cutout into the control board (
¶ 81).
2. Check that the gasket under the front panel is located correctly.
3. Place the device in the mounting cutout and secure it against falling−down with one
hand.
4. Fit all screw clamp fixings as explained below:
 ‚
ƒ
ELx7xx−011
– Insert the screw clamp fixing into the slot in the housing of the device (see above
figure).
– Press the screw clamp fixing downwards, tilt it towards the housing and check
that it has firmly snapped into place.
– Tighten the screw clamp fixing hand−tight with a screwdriver.
5. Check that the device is securely located in the mounting cutout and that the front
panel gasket is located correctly.
– If necessary, realign the device/gasket.
– If the gasket is not located correctly, protection class IP65 is not achieved on the
front of the device!