Lenze CAPS−PACK - Handbuch (Seite 30)

Safety instructions
Product−specific safety instructions
2
l
30 LDCDS−2701 DE/EN 3.0
Commissioning
ƒ If required, you have to equip the system with additional monitoring and
protective devices in accordance with the respective valid safety
regulations (e. g. law on technical equipment, regulations for the
prevention of accidents).
Maintenance and servicing
ƒ The components are maintenance−free if the required operating
conditions are observed.
ƒ If the cooling air is polluted, the cooling surfaces may be contaminated or
the air vents may be blocked. Under these operating conditions, the
cooling surfaces and air vents must be cleaned at regular intervals. Never
use sharp objects for this purpose!
ƒ After the system has been disconnected from the supply voltage, live
components and power connections must not be touched immediately
because capacitors may be charged. Please observe the corresponding
notes on the device.
Disposal
ƒ Recycle or dispose of the product according to the applicable regulations.
2.2 Product−specific safety instructions
ƒ The device must not be charged by means of external battery chargers.
ƒ The housing must not be opened.
ƒ A short circuit in the connected cable will destroy the device (for example
when the cable is cut by an electrically conducting blade).
ƒ In case of an error, unplug the device immediately. Then, return the device
to the manufacturer. The address can be found at the back of this
documentation. Please use the original packing to return the device!