4 first steps with global drive control, 1 general, First steps with global drive control – Lenze GDC GDC getting started Benutzerhandbuch
Seite 43: General, 4first steps with global drive control, Global drive control
Global Drive Control
L
41
GDC DE/EN 4.0
4
First steps with Global Drive Control
4.1
General
The program GDC distinguishes between online and offline mode.
·
Offline:
No connection with the target system. This mode is useful for preparatory parameterization in
the office or for documentation purposes. No components but a PC are required.
·
Online:
GDC communicates via the serial/paramellel PC port or via a fieldbus−specific PC connection
module with the target system. This mode is required for the commissioning of the target
system.
Note
The GDC default setting is serial port COM2 and system bus (CAN) port (500kBaud/parameter
channel 2) when "system bus (CAN) connection" has been selected for installation.
·
If you want to use another port you have to configure it in the GDC communication settings.
(Refer also to the tip on the next page.)
·
Further information on target system communication can be obtained from the GDC online
help.