Lenze GDC GDC getting started - Handbuch (Seite 45)

Global Drive Control
L
43 GDC DE/EN 4.0
4.3 Find target system (Online mode)
The dialog box Find drives is opened automatically when GDC is started in online mode.
·
You can call the dialog box Find drives using one of the following possibilities:
– Press the function key F2
– Select Drive W
Find.
– In the toolbar, click on the button
To search a drive you can enter different settings which are dependent on the port used: (see also
Abb. 7)
·
Browse all baud rates: (only for Lecom−A/B)
Activate the check box to browse all baud rates from 1200 to 19200 baud.
·
Quit search when drive found:
Activate the check box to cancel the search once a target system has been found.
·
Search drives: (only for Lecom−A/B)
Activate the check box to include slave drives in your search.
·
Drive addresses:
Enter the range of controller addresses which you want to find.
Click the button Search to start searching or click Cancel to abort.
Tip!
GDC automatically tries to allocate device descriptions to the target systems found.
·
If only one target system was found and a device description could be allocated, the device
description is loaded immediately.
·
If the automatic allocation to the device description fails a dialog box appears in which you can
select the suitable device description manually.
Further information on manual selection
– of a basic controller can be found in section 4.4.
( ^ 45)
– of an AIF module can be found in section 4.5.
( ^ 46)
– of FIF modules can be found in section 4.6.
( ^ 48)