Weidmuller AI8 - Multi channel signal transmitter - Handbuch (Seite 26)

6
Display Operation
The display can be set up to automatically scroll through the various
items of display information or just the input values. Alternatively, you
can set it so that the up and down scroll the display up or down. The
display information shows the input measurements, alarm status and
analogue output signal.
Remote configuration
If the unit has the digital communications option you can configure the
unit using the software provided. If not then you should use the front
panel key pad as described below.
Reviewing the setup
For review mode, press the MENU key and Press ENT to select Review
mode. To navigate through the menus, use
• the
&
and
^
keys to scroll forward or backwards
• the ENT key to select a menu item
• the EXIT key to step out of a menu
Note: You can use review mode while the instrument is in service and
the analogue output, digital communications and alarms will continue
to operate correctly.
Changing the setup
For setup mode, press the MENU key, scroll the display until it shows
‘Set-up Mode’ and Press ENT to select set-up mode. You will be
asked for a PIN number (the default for set-up is 100). There is a full
description of the setup mode in the following pages.
Clearing tripped alarms
You can acknowledge a tripped alarm by simply pressing the key
for that channel (below alarm led). The alarm led will flash red for
unacknowledged alarms.