Blomberg TKF 7230 - Handbuch (Seite 7)

6 - EN
Rotate the feet to adjust until the machine
stands level and firmly.
C Never unscrew the adjustable feet
from their housings.
Ventilation hose and
connection (for products
equipped with an outlet vent)
Ventilation hose assures exhausting of the
air from inside the machine.
There are 3 air outlets on the rear, left and
right sides of a vented dryer. The sides are
covered by a replaceable plastic cover.
Stainless sheet metal or aluminum pipes
can be used instead of the hose. The
diameter of the pipe to be used should be
minimum 10 cm.
Maximum hose and pipe lengths are given
in the table below.
Hose Pipe
Maximum length 8 m 10 m
1 elbow 45° -1.0 m -0.3 m
1 elbow 90° -1.8 m -0.6 m
1 elbow 90° short -2.7 m
1 wall passage -2.0 m -2.0 m
C Each elbow and other passages
should be subtracted from the above
maximum length.
To connect a ventilation hose;
1. Fit the hose adaptor (90° or flat
adaptor) by pressing it on the air outlet
at the rear of your machine. Close
the remaining 2 air outlets with plastic
covers.
2. Connect the air outlet hose to the
hose spacer piece (90° or flat adaptor)
by turning it anti-clockwise.
3. Make the hose passages as shown
below.
3 Installation
Appropriate installation
location
• Install your machine in environments
which have no risk of freezing and in a
stable and level position.
• Do not place your machine on a long
pile rug or on similar surfaces.
• Operate your machine in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the machine with materials
such as long pile rugs and wooden
bands.
B Make sure that your machine is not
placed on the power cable.
B Keep at least 1. 5 cm from the edges
of other furniture.
Under Counter Installation
• A special part (Part no 295 950
0100) replacing the top trim must
be provided and installed by the
Authorized Service in order to use
the machine under a counter or
in a cupboard. It should never be
operated without the top trim.
• Leave at least 3 cm of space between
the side and rear walls of the machine
and the walls of the counter/cupboard
when installing your machine under a
counter or in a cupboard.
Use on a washing machine
• A fitting device should be used
between the two machines for use on
a washing machine. The fitting device
(Part no. 295 560 0100 white/ 295
560 0200 grey) must be installed by
the Authorized Service.
• Place the machine on a sound floor. If
it is to be placed on top of a washing
machine, the approximate weight
together may reach 180 kg when they
are full. Therefore, the floor must be
capable of carrying the load on it!
Adjusting the feet
In order to ensure that your machine
operates more silently and vibration-free, it
must stand level and balanced on its feet.
Balance the machine by adjusting the feet.