Clearaudio EMOTION SE - Handbuch (Seite 13)

Emotion SE
User manual / Bedienungsanleitung
Page / Seite 12  Clearaudio electronic GmbH 2013
3.2 Adjustment of the Antiskating
alignment of the antiskating tracking force position of the antiskating-screw
minimal antiskating 10 – 15mN see illustration 1
medium antiskating 15 – 20mN see illustration 2
maximum antiskating 20mN and more see illustration 3
3.3 Setting-up of the motor
Take the motor-pulley out of the accessory bag and shift
the motor pulley as far as on the motors shaft until you have a
distance of approximately 1 mm between the upper
edge of the motor and the lower edge of the pulley.
Now tighten the three screws in the pulley one after the other
with the precision screw driver.
Now place the motor unit into the stainless steel motor stand and fix the motor with the two
screws on the side of the motor stand. Place the motor unit into the cut out on the left side
of the turntable chassis and pay attention, that the switch of the motor faces outside.
Now you can connect the power cord to your
power outlet.
Place one drive belt around the platter and around
the pulley.
The smaller diameter of the pulley is used for 33
1/3 rpm and the larger diameter for 45 rpm.
The position „I” on the motor-switches the motor
on.
Before first use, let the turntable run in for the first 15 to 30 minutes.
Pic. 12: Antiskating adjustment
Pic. 14: Drive belt mounting
Illustration 1 : Minimal
antiskating
(Screw is almost removed)
Illustration 2 :
Medium antiskating
(Screw is at half position) Illustration 3 :
Maximum
antiskating
(Screw is screwed in)
Pic. 13: Mounting the pulley
1 mm