Clearaudio CHAMPION BASIC - Handbuch (Seite 17)

Champion
Bedienungsanleitung
USER MANUAL
Seite/Page 17 © clearaudio electronic GmbH 2007
19. Place the belt first round the platter, then round the smaller diameter of the pulley (33 1/3 rpm).
20. The tension of the belt can be changed by turning the motor
about its axis. The tension is correct if the correct turntable
speed is achieved within 10 seconds. If the tension is too
high, the motor could start to vibrate a little bit. If the
tension is too loose, the turntable will not achieve a constant
and correct speed.
21. For mounting the tonearm and the cartridge, please use the special User manual for
your tonearm and cartridge!
22. If you should have problems with hum, the turntable
may need to be grounded. In this case, connect the
grounding wire supplied to the screw of the bearing
and to the earth connector of your amplifier.
The Champion turntable is now completely assembled and you can now enjoy listening to music.