Clearaudio CHAMPION LIMITED - Handbuch (Seite 6)

Champion
Limited
User manual / Bedienungsanleitung
Page / Seite 5  clearaudio electronic GmbH 2008
5. Take the motor and place it in the indent of the
chassis. The switch should be on the outside of
the turntable and the space between motor and
chassis approx. 1cm
6. Place the belt first round the platter, then round the smaller diameter of the pulley
(33 1/3 rpm). For a better figurative representation the belts shown in the user
manual are in black colour (original transparent).
7. The tension of the belt can be changed by turning the
motor about its axis. The tension is correct if the correct
turntable speed is achieved within 10 seconds.
If the tension is too high, the motor could
start to vibrate a little bit. If the tension is too loose,
the turntable will not achieve a constant and correct
speed.
8. If you have a hum noise in the platter bearing, please
ground the bearing with the grounding cable! Please put
the male plug in the hole of the bearing screw.
For mounting the tonearm and the cartridge, please use the
special user manual for your tonearm and cartridge!
clearaudio wish you a lot of pleasure with your Champion Limited turntable!
3. Speed calibration
Install the drive belt, first around the platter, then around the motor pulley. There are
two diameters on the motor pulley:
• smaller for 33 1/3 rpm
• larger for 45 rpm
To correctly adjust the belt tension, turn the motor around its axis. Proper tension will
be achieved through eccentric placement of the motor pulley or if you have enough
space on your platform, just change the distance between the motor and the turntable
chassis. The belt tension is correct if the belt can be deflected by approximately ¾inch
by a finger.
Picture 5: Placing the motor
Picture 6: Turning the motor
Picture 7: Grounding the bearing