Clearaudio ACCU DRIVE - Handbuch (Seite 6)

Accu Drive
Page / Seite 6
 clearaudio electronic GmbH 2013
User manual / Bedienungsanleitung
4. Operating information
 The Accu Drive can be used without connection to the mains power supply.
However it is recommended to maintain connection to the mains power supply
because the batteries will be automatically recharged and battery life is
extended because the Accu Drive’s control electronics are being supplied from
the mains power supply and not the internal batteries.
 If the front button is not pressed for 30 seconds the display returns to
“Status information” (see page 4).
 As long as a load is connected to the Accu Drive and the remaining charge level is
sufficient for operation of the connected device there will be no charging.
 When there is no load on the Accu Drive it automatically returns to charging mode to
ensure it is ready for use.
 A reduction of the output voltage of up to 2V between two charging cycles is normal.

The high precision controlled speed of the turntable is dependent on the low ripple of
the power supply, not absolute voltage level.
 When the indicated charge level reaches 9% the batteries are nearly empty and should
be charged as soon as possible.
Please note:
The remaining operating time and the battery charge level are only estimates based
on measured values.
To prevent overheating of electronic parts never cover or put anything on top of the
Accu Drive.
Do not dispose of the unit in the domestic waste.
Do not expose the Accu Drive to a temperature above 40° Celsius.
If the Accu Drive is not in use for an extended period, turn it off at the rear panel
switch.
Clearaudio electronic GmbH
Spardorferstraße 150
91054 Erlangen
Germany
Tel/Phone: +49 9131 40300100
Fax: +49 9131 51683
www.clearaudio.de
www.analogshop.de
[email protected]