Clearaudio SYNCRO - Handbuch (Seite 2)

Syncro Power Generator
User manual / Bedienungsanleitung
Seite/Page 2  clearaudio electronic GmbH 2014
User manual 2 - 4
Bedienungsanleitung 5 - 8
Dear Clearaudio customer,
thank you for your decision to purchase the world class Clearaudio Syncro Power Generator (SPG) .
Please take a moment to read this user manual to avoid any possible damage, to ensure correct
setting up and to learn how proper care of your Syncro (SPG) can give you many years of enjoyment.
The Clearaudio Syncro (SPG) will improve the sound quality of all high end audio systems.
You will immediately notice a larger, more stable and transparent sound stage.
It simply improves the sound of your systems components better by eliminating any distortion and
voltage or frequency fluctuations.
Any further questions concerning the Clearaudio Syncro (SPG) or other products made by
Clearaudio should be directed to your local distributor or directly to the Clearaudio- hotlines
(Phone: +49(0) 1805/059595).
Clearaudio electronic GmbH
1. Introduction
Most AC power lines contain unusually high amounts of noise and fluctuations of voltage and
frequency. They may also contain distortion of up to 10 %. Standard power supplies cannot eliminate
all this noise and distortion. Some power line filters can help, but can do nothing about fluctuating
voltage or frequency. Clearaudio's Syncro (SPG) will eliminate all these problems and will actually
improve the sound quality of your system, thus taking it to a new level of realism.
The Clearaudio SPG combines two units in one housing:
 Distortion free AC power with constant line voltage 230V~ or 115V~
 Constant frequency generator variable between e.g. 47 to 89 Hz
On the front panel (right), you will notice a switch bottom and blue control LED for 33 rpm and for 45
rpm marked. While channel 1 can be set to a fixed working frequency of 50 Hz (33 rpm), channel 2
can be set to higher frequencies e.g. 67,5 Hz ( 45 rpm). The actual working frequency can be
switched any time during operation between 50 Hz and any 67,5 Hz or other frequency.
The power supplies on most airplanes and ships were designed for a working frequency of 400Hz,
thus allowing a smaller, lighter power supply. If the power supplies of most audio equipment were not
designed properly for 50 Hz or 60 Hz operation, by being to small, it can often help in improving the
sound quality by increasing the frequency higher than standard.
The Clearaudio Syncro (SPG) can of course be used as an ultra clean power source for turntables.
With the selector switch on the right side of the Clearaudio Syncro (SPG) either 33 1/3 or 45 rpm can
be selected.
It is recommended to start in 33 1/3 switch position and than switch to 45 rpm.
Package Content:
The Clearaudio Syncro (SPG) is delivered in a special packaging to ensure a safe transport.
Please store this original packaging in case of any transportation or shipping.
Please check the contents immediately after unpacking :

Clearaudio
Syncro Power Generator

One primary AC power cord

User manual

Warranty card

Clearaudio Quality Card