Clearaudio SYNCRO - Handbuch (Seite 4)

Syncro Power Generator
User manual / Bedienungsanleitung
Seite/Page 4  clearaudio electronic GmbH 2014
The right switch on the front panel changes operating frequencies between channel 1 (e.g. 50 Hz) and
channel 2 (any higher frequency).
If you are using your Clearaudio Syncro (SP)G with a Clearaudio turntable, Blue control LEDs will
indicate the selected speed (either 33 1/3 or 45 rpm). The exact turntable speed can be controlled by
using the Clearaudio Stroboscope Test Record (AC038) and the Clearaudio 300 Hz Speed light (Set
with Record: AC076), available under: www.analogshop.de !
3. Frequency and speed tuning
The Clearaudio Syncro (SPG) allows you to set and maintain an exact frequency / speed by slowly
turning the calibrating screws "cal 1" and "cal 2" (also located on the front panel and marked 33 rpm
and 45 rpm). The left calibration screw marked "33 rpm" adjusts channel 1, while the right calibration
screw marked by "45 rpm" adjusts channel
Please check the speed with a Clearaudio stroboscope light and stroboscope Test Record and enjoy
the music.
4. Operation options
You can use the Clearaudio Syncro (SPG) with following devices:

Turntable

Phono-Preamplifier

Micro-Phonopreamplifier
5. Technical specifications
Mains voltage: 115 / 230 V – 50 / 60 Hz
switchable on the back panel
Fuse: at 115 V / T 0,25 A
at 230 V / T 0,125 A
Output voltage: 115 / 230 V switchable in the device
output frequency:
infinitely variable approx. 47 – 89 Hz
Display
Maximum output power: max. 8 W
Output: low heat device socket
Dimensions (approx: W x D x H in inch): 7.09 x 7.48 x 2.17 inch
Dimensions (approx: W x D x H in mm): 180 x 190 x 55 mm
Weight (only Syncro): 2,15 kg
Warranty*: 3 years
* Only if the warranty card is filled out correctly and sent back to Clearaudio!
Clearaudio electronic is not responsible for typographical errors in descriptions. Technical specifications subject to change or
improvement without prior notice. Availability as long as stock lasts. Copies and imprints- also only in extracts – require written
conformation through Clearaudio electronic GmbH; Germany
Picture 2
Slide-switch for input voltage
between 115/230 V
Fuse: 230 V T 0,125A
115 V T 0,25A
If you change the input voltage you also must
change the output voltage inside the Syncro
(look at picture 1) to the same value!
Stand: August 2014