Gossen DIGISKY Part 2 Benutzerhandbuch
Seite 12
GOSSEN Foto- und Lichtmesstechnik GmbH
12
3.3
Tools / Edit
The following tools are available:
Auto scanning (flash units and modules)
Add manually (flash units)
Save studioset (configure user-specific settings)
Clear studioset (delete user-specific settings)
Use the ring controller to
navigate to Tools / Edit
3.3.1
Auto Scanning
User-specific setting can be configured here. These setting are saved to the
Digisky and are retained even when the batteries are replaced.
Select Auto Scanning with
the ring controller and
continue to the Cancel/OK
selection.
Start auto scanning by
pressing the M key.
I
Flash units / receivers which belong to a stored studioset and are switched off are identified in
the device list as offline: “OFFL”.
I
In the case of a previously saved studioset, newly detected flash units / receivers are added to
the list during auto scanning. The “new” set can also be saved.
I
Studiosets which have not been saved are not retained after the DIGISKY is switched off! Auto
scanning is started again when the device is switched back on.