Gossen DIGISKY Part 2 - Handbuch (Seite 8)

GOSSEN Foto- und Lichtmesstechnik GmbH 8
Use the ring controller ...
to select the desired value.
Press the M key ...
to acknowledge.
After selecting the desired RF mode, enter
the desired RF channel to your DIGISKY
using the same procedure.
After doing so, don’t forget to acknowledge
entry by pressing the M key.
EL-Skyport units and modules must be switched on no later than at this point in time.
Press the menu key ...
to exit the main menu.
The DIGISKY starts initializing the radio
network and is switched directly to the
radio menu.
Up to 6 units/modules are displayed.
!
The time it takes to initialize the radio network depends on the number and type of receivers.

If EL-Skyport software and/or the EL-Skyport app are active in addition to the Digisky, errors
occur in the descriptions list for the RX units and modules.
If not all of the units/modules are included in the list, run “Auto Scanning” once again (see
page 12).
If you’re using units without “EL-skyport RX remote control”, these will have to be added
manually (see “Adding Devices Manually” on page 13).
I

Save found studiosets to memory if you will use them frequently
(see section 3.3.3, “Saving Studiosets”, on page 14).
Initialization can be avoided in this way when you switch your DIGISKY on. In this case, only
the devices/modules in the stored sets are detected and initialized.