Gossen DIGIFLASH 2 - Handbuch (Seite 32)

8 GOSSEN Foto- und Lichtmesstechnik GmbH
1 The functioning of the exposure meter
1.1 Preparation and self-test
Battery
The exposure meter is powered by a 3 V Lithium battery, type CR 2032. When the battery is running
low, BAT appears in the display.

The battery should be replaced as soon as possible. When BAT is shown alone in the display, the
battery will need to be replaced before further measurements are possible.

To replace the battery, pull out the battery compartment located under the eyelet for the carrying
cord.

Remove the old battery and insert the new one. Observe the "+" and "-" polarity.

Close the battery compartment.
Attention! The exposure meter is provided with a battery memory of 10 seconds. If the battery is
removed briefly or replaced only within those ten seconds, the values stored in memory will be
maintained. Otherwise changing the battery or pressing one of the buttons will cancel all the
individually stored values.
Self-Test
After the new battery has been inserted, the microcomputer
will carry out a self-test. Every display segment appears in
the display panel. The self-test takes 10 seconds. It can be
interrupted before by pressing any button. After the self-test,
the standard settings will be shown as set by the factory.
Standard settings
ISO: 100/21° COR: 0 EV: 8 t: 1/125