Baumer NE214 - Handbuch (Seite 13)

NE214
www.baumer.com 13
Error description in particular:
Error 1 : Format error (<ETX> not in correct position). This error may occur for
example if the data format has not been observed when programming
(e.g.: when programming the Start Count, only 5 digits instead of 6
are transmitted).
Error 2 : Line (position) not available or separating line
Error 3 : Parameter error (non-admissible value in protocol). This means, for
example, that the scaling factor does not only consist of digits, but
also of other non-admissible characters, or that a value has been
indicated that is not within an admissible range.
7. List of the control characters in use
Control character Hex Decimal
<STX> 02 02
<ETX> 03 03
<ACK> 06 06
<LF> 0A 10
<CR> 0D 13
<DC1> 11 17
<CAN> 18 24
<DEL> 7F 127