VACUUBRAND Kit AK + CVC 3000 - Handbuch (Seite 10)

Seite 10 von 12 // page 10 of12
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen. 999195 // 05/02/2008
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 999195 // 05/02/2008
Pull controller PC 3001 basic out of the stand housing.
Unplug connection cable.
Assemble the catchpot at the inlet using joint clip.
Position hose clips at the ends of the hoses.
Connect the hose to the controller at the lower hose connec-
tion and the hose to the pump at the upper hose connection
at the new inlet block.
Close hose clips using a flat pliers.
Position inlet block in the holder and assemble counterholder
with two screws using Torx screw driver.
Position union nut with clamping ring on the connection hose
and assemble to the vacuum connection of the controller CVC
3000.
Plug connection cable in the controller.
Insert controller into stand foot.