VACUUBRAND Kit AK + CVC 3000 - Handbuch (Seite 9)

Seite 9 von 12 // page 9 of 12
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen. 999195 // 05/02/2008
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 999195 // 05/02/2008
Remove both screws at the counterholder at the inlet block
using Torx screwdriver.
Remove counterholder with screws.
Remove hose at the inlet block.
Assemble hose in the stand foot.
Assemble the less bended side of the hose in direction of the
inlet.
Assemble the more bended side of the hose downwards.
Open hose clip at the inlet block by using a flat-bladed screw
driver.
Position screw driver as shown in the figure and turn.