VACUUBRAND VMS-B Modul - Handbuch (Seite 10)

Seite/page 10/16
Das Dokument darf nur vollständig und unverändert verwendet und weitergegeben werden. Es liegt in der Verantwortung des
Anwenders, die Gültigkeit dieses Dokumentes bezüglich seines Produktes sicher zu stellen. BA-Nr.: 999236 / 05/09/2011
Documents are only to be used and distributed completely and unchanged. It is strictly the users’ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999236 / 05/09/2011
Safety information!
The VMS-B-Modules are to be connected only to the VACUUBRAND BUS system
VACUU•BUS TM !
Connect the VMS-B-Module only to VACUUBRAND vacuum controllers, a VACU-
UBRAND vacuum diaphragm pump and VACUUBRAND valves.
Read the manual before installing or operating the equipment.
Remove all packing material, remove the product from its packing-box and inspect
the equipment.
If the equipment is damaged, notify the supplier and the carrier in writing within three
days; state the item number of the product together with the order number and the
supplier’s invoice number. Retain all packing material for inspection.
Do not use the equipment if it is damaged.
Read and comply with this manual.
Obey national safety regulations and safety requirements concerning the use of
vacuum and electrical equipment and adopt suitable safety measures.
☞ The product must be connected only to a suitable fused and protected electrical
supply and a suitable earth point. Failure to connect the device to ground may
result in deadly electrical shock.
☞ Check that mains voltage and current conform with the pump and the cooling
water valve.
☞ If pumps with start-up control (MD 8(C), MZ 8(C), ME 16(C), MD 12(C), MV 10(C),
RZ 9, RC 6) are managed, the pump might not start running in case of frequent
on/off switching at short intervals.
VACUUBRAND ATEX pumps must not be switched on/off frequently than 1x per
hour.
☞ Ensure that installation is in compliance with limitations from the degree of pro-
tection, see section „Technical data“. Make sure ventilation is adequate if the
product is installed in an enclosure or if ambient temperature is elevated.
➨ Electronic equipment is never 100% fail-safe. This may lead to an ill-defined sta-
tus of the equipment or of other connected devices. Provide protective measures
against misfunction and failure. Ensure that in case of failure the controller and
the vacuum system always will turn into a safe status.
☞ The switching of the pump or a cooling water valve must not lead to a critical
dangerous situation under any circumstances.
• Use only OEM spare parts and accessories.
• Otherwise safety and performance of the equipment as well as the electromag-
netic compatibility of the equipment might be reduced.
Obey all other relevant safety requirements (e. g. accident prevention regulations for
working in laboratories and explosion protection guidelines). Adopt suitable safety
measures.
Ensure that maintenance is done only by a suitably trained and supervised techni-
cian. In order to comply with law (occupational, health and safety regulations, safety
at work law and regulations for environmental protection) components returned to
the manufacturer can be repaired only when certain procedures are followed.
NOTICE
NOTICE