AUDIOLINE BabySense5-Video - Handbuch (Seite 43)

7
GB
Use these buttons to adjust the limits (lower limit Off, 12, 15, 18 / upper limit: 20, 23, 26,
Off). When set to “Off” the temperature monitoring is deactivated.
Switching the night light on/off
Press the button five times.
This icon appears in the display.
Use these buttons to switch the night light on the transmitter on or off.
Switching the vibration alarm on/off
Press the button six times.
This icon appears in the display.
Use these buttons to switch the vibration alarm on or off.
When the vibration alarm is activated, the receiver vibrates when sounds in the room
being monitored are so loud that the red Sound Level LEDs are activated.
Adjusting the VOX sensitivity
(VOX: Voice Operated Transmission = Sound detection)
The VOX function (sound detection) causes the system to start transmitting automatically from the
transmitter to the receiver immediately a voice or sound is detected.
Press the button seven times.
This icon appears in the display.
Use these buttons to set VOX to OFF or adjust the sensitivity to one of 5 levels (5 = hig-
hest sensitivity). When one of the five levels has been set, the VOX icon lights up in the
display.
If the receiver is placed on the charger the display will switch off after approx. one minute of inactivity,
but will switch back on if triggered by the vox detector in the transmitter or by pressing any button on
the receiver.
However if VOX is set to OFF, the display will remain on all the time.
Video/Audio switching
You can manually switch off the display to save battery power. The sound from the baby’s room are
to be heard permanently and the display will automatically switch on again if triggered by the vox
detector.
Press this button briefly.
For switching the display on again press this button again briefly.
Operating the Receiver