Dynaudio Evidence - Handbuch (Seite 6)

6 Dynaudio Evidence
Connecting
Connecting
Connecting the loudspeakers
1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of the
cabinet (see Fig. 2). The high quality, gold plated binding posts can accommodate
different connection systems:
–
4-mm-plugs (“banana plugs”): The pins can be put directly into the binding post
without any tightening necessary.
– Cable spades: Un-tighten the binding posts, insert the spade into the opening, and
secure the spade by tightening the posts.
– Bare wires: Un-tighten the binding posts and place the cable into the binding
posts. Tighten the posts.
Note:
• With every connection system, ensure that the contact is tight and has a proper
contact area.
• Connectors with similar gold plating as the loudspeakers binding posts will typically
offer the best results and remain corrosion-free.
• Please ensure that the positive and negative cables do not make contact with each
other.
• Tighten the posts, and check the contact after a few days to make sure that it hasn’t
loosened.
Fig. 2 Binding posts at rear of cabinet.
Evidence.book Seite 6 Montag, 12. Januar 2009 2:04 14